Monkey see Monkey do....

--Post 06--

With some more refinenment to the model, it was getting to the stage where a 3dprinting company was needed.

After much searching, a few unresponsive mails and general summing up I decided on a company based in the States for my maiden run. My first print would be around 28mm (wargames scale) my first "wee-man"

Its a Monkey!

--Post 06--

And here it is, still some refining but this will be my first attempt. Hopefully the printing process won't be too painful or expensive.

I decided to go slightly simple in the design as I'm expecting to lose some of the detail. My main worry will be the face and eyes as they may be lost.

Areas such as the club,gun and the straps haven't been touched again to see how the printing holds up.

Fingers crossed.

--Post 05--

Started to refine the detail of the figure, With the understanding that a alot of the detail may not come through in the print. At this stage it would all be guesswork. When it came to creases and folds I had to guess how far to go, this is trickier than it sounds( at least to me) not just for the figure to look good at scale but these bumps and lump would help define where the painter would put their paint...and if there were no peaks then the figure could look too flat and liflefess.(picture to follow)

This also was a good excuse to go back and watch the movies,